Menu

Roof Loggia

Installation tips for fastening a roof loggia


Due to the sloping ceilings it is quite hard to draw a cat net with the continuous minimal height of 2 ms. 

The BOY cats net can only be installed without drilling when the loggia has a handrail. Otherwise you need to fasten a corner wall bracket in the two front corners of the loggia. Depending on the size of the loggia wall brackets ought to be secured to the wall with 2 m distances with 4 screws each. In the holder, the telescopic rods are used with telescopic pole attachments. 

Attaching the cat net is really simple. Keep the net on the balcony railing and push it slightly. Mark the top loop of the vertical row of stitches, the one through which later the telescopic rod has to be threaded through. Thread the telescopic rod at approximately every 20 cms with some stitches. This will give you the same tension on the net on the entire surface. 

To avoid the sagging of the cat net, pull the braided line spirally through the top stitch row. The braided cord should be threaded through the hole in the telescopic rod while slightly pressed and knotted. You can also provide the cat net with an edge border trimming instead of a braided line. This saves a lot of work and you have a clean finish to the net. The cat net is then secured with net ties at the top of the telescopic rods. 

You can get a safe conclusion at the bottom of the masonry, for example, by (etc. available eg a bamboo rod at the hardware store) pulling through a bar through at the masonry end stitch and then secure it with hooks on the wall (please pay attention here that the cat net is, again, slightly tensioned). 

Required mounting equipment: 

- Boy-cat-net 
- Telescopic rods
- Telescopic rod attachments 
- Net-binder 
- Telescopic rod holders 
- Hooks with anchors (only if drilling is permitted) 
- Braided cords and net yarn 


  1. Hooks and dowel Set

    Hooks and dowel Set

    Plastic coated metal hooks and dowel Set
    Price: €2.95 per Set
    Incl. 19% VAT, Excl. shipping
    Lieferzeit 3 Days

    In stock

  2. Wall mount for telescope rods

    Wall mount for telescope rods

    Strong wall mounts for the extendable BOY-telescopic rod. It is suitable for all walls and parapets, in which you may drill holes. This wall mount has to be fastened with 4 screws. Suitable for telescopic rods with a diameter of 19mm only.

    Available in the colors : white, black and zink plate

    Price: €11.95 per Piece
    Incl. 19% VAT, Excl. shipping
    Lieferzeit 3 Days

    In stock

  3. Floor mounting for telescope bars with a triangle shaped base plate

    Floor mounting for telescope bars with a triangle shaped base plate

    Telescopic rod holder - suitable for any right-angled floor corner. The bottom plate has the shape of a right triangle and therefore. It is anchored by two strong screws into the ground. This mounting is suitable only for our BOY-telescopic rods with a outer diameter of 19mm.

    Available in the colors: white, black and silver zink plated

    Price: €15.95 per Piece
    Incl. 19% VAT, Excl. shipping
    Lieferzeit 3 Days - ex Warehouse

    In stock

  4. Wall clamp for telescopic rods

    Wall clamp for telescopic rods

    Wall clamp for telescopic rods with a max. Ø 23mm to be fixed onto walls without drilling. This clamp provides a strong hold to the telescopic rods.

    Price: €19.95 per Piece
    Incl. 19% VAT, Excl. shipping
    Lieferzeit 3 Days - ex Warehouse

    In stock

  5. Net Yarn, Length 20m, Ø 1mm

    Net Yarn, Length 20m, Ø 1mm

    This Net Yarn with a diameter of 1mm and a length of 20m is very useful to attach nets together or to repair nets. It is also recommended to be used to tie the nets to railings or to telescopic rods.
    Price: €2.95 per Rolle
    Incl. 19% VAT, Excl. shipping
    Lieferzeit 3 Days - ex Warehouse

    In stock

  6. Telescopic rod - extendable from 110cm up to 210cm

    Telescopic rod - extendable from 110cm up to 210cm

    Telescopic rods are the most commonly fixtures used for attaching cat netting on balconies, terraces and gardens. Our rods are very stable and strong in order to with stand wind and weather. Our telescopic rods are made from reinforced steel with a wall gauge of 1 mm and the diameter of the rod is 19mm - the inner rod 16mm.

    Price: €8.95 per Piece
    Incl. 19% VAT, Excl. shipping
    Lieferzeit 3 Days - ex Warehouse

    In stock

  7. Over climbing protection Top Part attachment for our extendable telescopic rod

    Over climbing protection Top Part attachment for our extendable telescopic rod

    This 45 degr. angled over climging protection for our extendable telescopic rods will prevent your cat from escaping over the Cat-Net.

    Price: €8.50 per Piece
    Incl. 19% VAT, Excl. shipping
    Lieferzeit 3 Days - ex Warehouse

    In stock

  8. Corner mounting for telescopic rods

    Corner mounting for telescopic rods

    With this sturdy corner mounting our BOY telescope bars are optimally mounted into the corner of your balcony. It will be fixed with 4 strong screws to the wall.
    Suitable only for our BOY telescopic rods with a diameter of 19mm.

    Available in the colors: white, black and silver zink plated

    Price: €12.95 per Piece
    Incl. 19% VAT, Excl. shipping
    Lieferzeit 3 Days - ex Warehouse

    In stock